Apply joint compound. Dip a joint knife sideways into the container of joint compound and load about half of the blade. Run the knife over the dented area to smooth on the joint compound. Turn the blade at a 90 degree angle to the wall and run it over the area again to remove excess compound.

Quick fixes for the 8 most common drywall flaws, including nail pops, cracks at corners, bubbled or loose tape and holes. Fix them right before you paint fo. Using a putty knife, spread drywall compound over the entire patch, feathering out the edges beyond the patch onto the wall. Allow the compound to dry and sand it smooth. Then repeat the process, each time spreading it a little further out from the edges of the patch.

• Be sure to remove the extra compound, so that the area won't have bumps once the the substance dries. • Check the area it it dries to determine if the dent has been completely filled. Best Jquery Sliders. You may need to apply a second coat if the joint compound shrinks as it dries.

Patching: When patching smaller holes, a 6' taping knife should suffice. Apply the compound in a few light coats rather than a single heavy coat, and sand between each coat. You can either sand the patch using a sanding block like the, or wet sand using a slightly damp rag. If you choose to wet sand, let the area dry before applying the next coat. For larger holes, you'll have to fill the hole with something solid before you apply compound (don't try to fill the hole with mud). Once the hole is filled, start with a 6' taping knife for the first coat.

Next, apply a few thin coats using a 10' taping knife feathering the compound out to blend into the wall. When working with drywall compound it's a good idea to use a Hawk, or a mud pan instead of working directly from the bucket. This will insure that you don't end up with little bits of junk in the compound, and that the compound in the bucket won't dry out too much while you're working.

They are also good for catching falling mud. Preparing the wall: Wipe the wall down with a dry rag, to remove any dust and dirt. Prime the whole wall with a proper primer, like. Any time you patch, it's a good idea to prime the entire wall. If you simply prime the patches, you may be able to see the patches when you're done.

Creature Feature Greatest Show Unearthed Zip more. Painting: Apply 2 coats of the desired paint, and you're done. If the patches were done properly (smooth and blended appropriately), after primer and two coats of paint you'll never know there was a patch there. NOTE: Products mentioned in this answer are for example only, I do not specifically endorse or recommend the use of any products mentioned.